** DIP1 is ON (LEDs enabled) and LEDs ENABLE input terminal is enabledĪdjust Microwave coverage area by using the trimmer on the PCB. Knowledge of the detector’s status and disables Anti-masking detection. While the system is armed this feature prevents an intruder from gaining The system status, Set (Arm) / Unset (Disarm). This input enables to control Anti-masking and LEDs operation in accordance to Success: Alarm relay is momentary opened. Used to perform remote alarm testing to the detector by applying 0 volts to this Indicates that the lens is dirty and requires cleaning.
Used to remotely control the LEDs when DIP1 is set to ON.Įnable: input is +12V OR no terminal connection When DIP8 is defined as Enabled this relay also opens momentarily when a Proximity AM The Proximity AM enables receiving sabotage alerts before the detector isĭamaged or masked, using both microwave channels. Trouble in the detector (not including dust/dirty lens). Normally closed AM relay output ( 24VDC, 0.1A) indicates Anti Masking alarm or any This terminal is a free pin that can be used to connect wires and EOL resistors For pole installation, the tamper can be moved to the bottom right-hand side of the internal base. Verify that you hear a "Click" when attaching the tamper spring to the wall.Ģ.
Close the front cover (Lock C1, Figure1)įor 45° right side installation use the equivalent units on the external base as follows:ġ. Secure internal base to external base (lockĨ. Insert external wires through external baseĦ.
Open knockouts on external base (Figure 3).Ĥ. Release internal base (unlock I1, Figure 2).ģ. The installation knockouts numbering are marked onĢ.
0 kommentar(er)
